Storcase-technology DS90 Manuel d'utilisateur télécharger pdf (Page 13)

Installation 7

DS90 User's Guide - Rev. C00 Kingston Technology Company

Drive Preparation

1. Remove the drive from its protective packaging.

2. Plastic Drive Bezel - When installing a hard drive equipped with a plastic front

bezel, remove the drive bezel before installing the drive.

3. SCSI Drive Termination - Disable SCSI termination on the drive. Refer to the

documentation provided by the drive manufacturer for the location of terminators

or jumpers. Termination is provided by an external terminator on the Data Silo

rear panel. External active termination is recommended for optimum SCSI

performance (external terminator not included).

4. SCSI Drive ID Select Jumpers - Locate the SCSI ID select jumper pins on the

drive, and remove any jumpers on these pins. The Data Silo SCSI ID cable will be

attached to these pins on the drive (Figures 6 and 7).

5. SCSI ID Cable - The SCSI ID cable consists of four wires twisted together. At the

end are two sets of connectors to support either 0.1 inch or 2mm connector pins for

attaching to the SCSI drive. The SCSI ID cable permits external unit ID selection

from the push-button switch located on the rear panel of the DS90 unit (Figure 3).

NOTE: Refer to the drive manufacturer's documentation for power, SCSI I/O, and

SCSI ID pin-out locations on your specific drive.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

Storcase-technology DS90 Manuel d'utilisateur Page 13